You are here

Handheld Drum Toppers

Compact, portable and customized for your application, the drum topper is an option you can carry wherever you need to go. Our drum topper provides many uses, including:

  • Filtering new oil directly from the drum
  • Allowing you to fill small totes
  • Acting as an offline filter for critical equipment

You can completely customize your drum topper below. Simply click on the desired options to create your specific drum topper unit.


Power Supply

What type of power supply do you need? Visit this page to learn more about these options.

Reset All
  • Automatic pressure relief valve
  • Non-bypass filter heads
  • Dual-stage filtration
  • 6' hose assemblies with various quick connect options
  • 25' power cord (for electric motors only)
  • Industrial powder-coated paint
  • One-year warranty
  • Decontaminating systems
  • Flushing new or repaired systems
  • Dispensing new oil
  • Pre-filtering new oil
  • Evacuating used oil
  • Topping off reservoirs
  • Collecting oil samples for analysis
Intended Use
  • To be used for offline, secondary filtration and not inline filtration
  • In general industrial environments, both indoors and outdoors (IP rating of 54)
  • For filtering mineral-based industrial oils and most synthetic oils with a maximum operating viscosity range of ISO 460 at 100°F/38°C within ambient temperature ranges of -8°F to 104°F (-22°C to 40°C)
  • Placed at the same level or below the equipment being filtered and within reach of the recommended standard 6 foot hoses
  • This system should be stored and used on a level surface, right side up, in a low-traffic area, and connected to the appropriate power source

Operating Temperatures:

  • -15°F to 150°F (-26°C to 66°C) for standard unit with clear PVC hoses
  • -20°F to 212°F (-28°C to 100°C) for custom unit with hydraulic hoses and Viton® or EPDM seals


  • Frame: Aluminum
  • Paint: Industrial powder coat
  • Filter Heads: Aluminum
  • Fittings: Zinc-plated steel and/or brass
  • Pumps: Aluminum/steel
  • Hoses: Clear PVC with steel wire
  • Gaskets: Buna-N

Filter Indicators:

  • Filter indicator pops at 22 psid (1.55 bar) as warning that filter elements need to be replaced

Pump Relief:

  • Opens at 65 psi (5.49 bar)


  • Approximately 45-50 lbs (20.4-22.7Kg). Will vary depending on options selected


  • 24.5"L x 13.5"W x 15.4"H

Viscosity Range:

  • 1 GPM pump:  ISO VG 10 to 460 at 100 °F (38 °C)
  • 3 GPM pump:  ISO VG 10 to 100 at 100 °F (38 °C)

* In colder temperatures the operator must take into account the fluid line temperature at start up to avoid damaging the pump.


Replacement Filter Element Part Numbers:

DC-S10000S04BBU 5-micron Filter Element
DC-S10000S04CBU 7-micron Filter Element
DC-S10000S04EBU 12-micron Filter Element
DC-S10000S04FBU 22-micron Filter Element
DC-S10000W04FBU Water Adsorption Filter Element

Elements are sold in cases of six and can be mixed and matched.